Raritan P2-UMT832M Mode D'Emploi
C
HAPTER
4:
O
PERATION
–
A
DMINISTRATOR
F
UNCTIONS
49
Video Delay
If switching between channels with different resolutions or that take too long to sync up when
you scan or switch channel ports on Paragon II (if it is an LCD monitor) creates an issue with
your monitor, set a video delay for channel port switching at your user station.
you scan or switch channel ports on Paragon II (if it is an LCD monitor) creates an issue with
your monitor, set a video delay for channel port switching at your user station.
If you set the video delay to any number of seconds greater than zero, Paragon II will wait until a
video signal is constant for that number of seconds before passing it through to the monitor. To
set video delay, use any of the arrow keys to move the highlight to the Video delay--switching
field, press ENTER to turn the highlight green, type in the desired two-digit delay from 00 to 30
seconds (or use the Ç and È keys to increment or decrement the field by 1), and press ENTER
again to select it.
video signal is constant for that number of seconds before passing it through to the monitor. To
set video delay, use any of the arrow keys to move the highlight to the Video delay--switching
field, press ENTER to turn the highlight green, type in the desired two-digit delay from 00 to 30
seconds (or use the Ç and È keys to increment or decrement the field by 1), and press ENTER
again to select it.
Press S to save the changes, or press ESC to exit without saving. The changes are applied only to
your user station (the station at which the change was made).
your user station (the station at which the change was made).