Alphasmart neo Mode D'Emploi
W
O R K I N G
W I T H
A
L P H A
S
M A R T
M
A N A G E R
Defining Settings for SmartApplets
NEO and NEO 2 by AlphaSmart
108
. . . . .
Defining Settings for SmartApplets
Like the System settings, the settings for each SmartApplet can be changed
either in the NEO Control Panel or in AlphaSmart Manager. Some settings
are different in the two locations.
either in the NEO Control Panel or in AlphaSmart Manager. Some settings
are different in the two locations.
The number of settings for each SmartApplet varies. AlphaWord Plus, for
example, has several settings; other SmartApplets have only one.
example, has several settings; other SmartApplets have only one.
You can only change settings for SmartApplets that are installed on all
connected NEOs or for SmartApplets that you have just chosen to install.
Only these SmartApplets are listed in the Settings list.
connected NEOs or for SmartApplets that you have just chosen to install.
Only these SmartApplets are listed in the Settings list.
Follow these steps to change SmartApplet settings using AlphaSmart
Manager:
Manager:
1. In AlphaSmart Manager, click the Settings tab.
2. Click the SmartApplet in the Settings List on the left
2. Click the SmartApplet in the Settings List on the left
A
.
3. Check the settings you want to change
B
; then, make your changes to
the settings.
Note: When you change settings, notice that AlphaSmart Manager
automatically checks the corresponding SmartApplet check box on the
left
automatically checks the corresponding SmartApplet check box on the
left
A
. If you uncheck this box, changes you make to those settings won’t
be sent to your NEO.
4. Click the Send List tab and verify that the settings you want to transfer
appear in the Send List Display.
5. Click Send. If you have set a send list password (see page 113), you must
enter the password and click OK.
A
B
Neo UG.book Page 108 Friday, August 31, 2007 8:03 AM