Alphasmart neo Mode D'Emploi
Warranty, Maintenance, and Contact Information
149
Maintenance tips
Storing your Neo
If you know you’re not going to be using your Neo for awhile, follow
these guidelines:
these guidelines:
•
If you’re storing a Neo that uses alkaline batteries, and you’re
going to be storing it for longer than six months, or the battery
capacity is less than 20%, remove the batteries from the device.
going to be storing it for longer than six months, or the battery
capacity is less than 20%, remove the batteries from the device.
•
If you’re storing a rechargeable Neo for between one and six
months, charge the device before you store it, and again after you
take it out of storage (to compensate for the battery pack’s self
discharge).
months, charge the device before you store it, and again after you
take it out of storage (to compensate for the battery pack’s self
discharge).
•
Just as for a single Neo, if you’re storing a group of rechargeable
Neos, be sure to charge all of them before you store them, and
then again after you take them out of storage.
Neos, be sure to charge all of them before you store them, and
then again after you take them out of storage.
•
Use care when storing or stacking a group of Neos. You may
inadvertently cause a power drain from some units if they are
stored incorrectly. If several Neos are stacked on top of each
other and offset somewhat, be careful that the rubber foot on the
bottom of any of the units does not touch the
inadvertently cause a power drain from some units if they are
stored incorrectly. If several Neos are stacked on top of each
other and offset somewhat, be careful that the rubber foot on the
bottom of any of the units does not touch the
on/off
key on the
top of any other units. If this occurs, the steady depression of the
on/off
key causes a small but constant battery power drain, even
though nothing may appear on the screen.
To avoid this potential problem, stack your Neos on edge or
carefully make sure they’re are stacked vertically with no offset.
You might want to enable the Two-button On option; see
“Two-button On setting” on page 68.
carefully make sure they’re are stacked vertically with no offset.
You might want to enable the Two-button On option; see
“Two-button On setting” on page 68.