Extreme summitpx1 Manuel D’Utilisation
4-14
Px Series Application Switch Installation and Configuration Guide
For example, to copy an image file saved as image1.xtr to switch with IP address
10.10.0.5 as the primary image using SCP2, you would enter the following command
within your SSH2 session:
10.10.0.5 as the primary image using SCP2, you would enter the following command
within your SSH2 session:
scp image1.xtr admin@10.20.0.5:primary.img
To copy the configuration from the switch and save it in file config1.save using SCP, you
would enter the following command within your SSH2 session:
would enter the following command within your SSH2 session:
scp admin@10.10.0.5:configuration.cfg config1.save
SSH2 Client Functions on the Switch
In ExtremeWare version 6.2.1 or later, an Extreme Networks switch can function as an
SSH2 client. This means you can connect from the switch to a remote device running an
SSH2 server, and send commands to that device. You can also use SCP2 to transfer files
to and from the remote device.
SSH2 client. This means you can connect from the switch to a remote device running an
SSH2 server, and send commands to that device. You can also use SCP2 to transfer files
to and from the remote device.
You do not need to enable SSH2 or generate an authentication key to use the SSH2 and
SCP2 commands from the ExtremeWare command-line interface.
SCP2 commands from the ExtremeWare command-line interface.
To send commands to a remote system using SSH2, use the following command:
ssh2 {cipher [3des | blowfish]} {port <portnum>} {compression
[on | off]} {user <username>} {debug <debug_level>} {<username>@}
[<host> | <ipaddress>] <remote commands>
The remote commands can be any commands acceptable by the remote system. You can
specify the login user name as a separate argument, or as part of the
specify the login user name as a separate argument, or as part of the
user@host
specification. If the login user name for the remote system is the same as your user
name on the switch, you can omit the username parameter entirely.
name on the switch, you can omit the username parameter entirely.
To initiate a file copy from a remote system to the switch using SCP2, use the following
command:
command:
scp2 {cipher [3des | blowfish]} {port <portnum>} {debug <debug_level>}
<user>@[<hostname> | <ipaddress>]:<remote_file>
[configuration {incremental} | image [primary | secondary] | bootrom]
To initiate a file copy to a remote system from the switch using SCP2, use the following
command:
command:
scp2 {cipher [3des | blowfish]} {port <portnum>} {debug <debug_level>}
configuration <user>@[<hostname> | <ipaddress>]:<remote_file>ave it