IBM 240 Manuel De Montage
Electrical safety notice
DANGER
Electrical current from power, telephone, and com-
munication cables is hazardous. To avoid shock
hazard, connect and disconnect cables as shown
next when installing, moving, or opening the covers
of this product or attached devices. The 3–pin power
cord must be used with a properly grounded power
outlet.
munication cables is hazardous. To avoid shock
hazard, connect and disconnect cables as shown
next when installing, moving, or opening the covers
of this product or attached devices. The 3–pin power
cord must be used with a properly grounded power
outlet.
Turn everything OFF.
First, attach all cables
to devices.
to devices.
Attach the signal
cables to the
receptacles.
cables to the
receptacles.
Attach the power
cord to an outlet.
cord to an outlet.
Turn the device ON.
To Connect
Turn everything OFF.
First, remove the
power cord from
the outlet.
power cord from
the outlet.
Remove the signal
cables from the
receptacles.
cables from the
receptacles.
Remove all cables
from device.
from device.
To Disconnect
Note:
In the U.K., by law:
The telephone line cable must be connected after the
power cord.
power cord.
The power cord must be disconnected after the tele-
phone line cable.
phone line cable.
Setting up your computer
You are now ready to assemble and start your computer.
1. Insert the battery pack into the battery compartment located
at the rear of the computer:
2
1
2
1
a. Line up the triangles on the battery and the computer
chassis and insert the battery pack.
When the battery pack is inserted, the battery pack latch
.1/
automatically clicks shut.
b. Switch the battery lock
.2/
to the locked position.
2. If you want to connect a printer to your computer, connect
one end of the printer cable to the parallel connector and the
other end to your printer. Then power on the printer.
other end to your printer. Then power on the printer.
2