Bunn axiom 35-3 Mode D'Emploi
Page 7
D
OPERATING CONTROLS
(A) ENABLE BREW ON/OFF SWITCH
Pressing the "ENABLE BREW ON/OFF" switch (indicator
on) supplies power to the brew station warmer, enables the
brew circuit, and energizes the tank refill circuit. Pressing the
switch again (indicator off) stops tank refilling and brewing
and de-energizes the brew station warmer. Stopping a brew
cycle after it has been started will not stop the flow of water
into the server until the funnel is empty.
Pressing the "ENABLE BREW ON/OFF" switch (indicator
on) supplies power to the brew station warmer, enables the
brew circuit, and energizes the tank refill circuit. Pressing the
switch again (indicator off) stops tank refilling and brewing
and de-energizes the brew station warmer. Stopping a brew
cycle after it has been started will not stop the flow of water
into the server until the funnel is empty.
NOTE – Hot water will be available at the faucet in a limited
amount when the "ENABLE BREW ON/OFF" switch is in
the "OFF" position because the tank will not refill.
amount when the "ENABLE BREW ON/OFF" switch is in
the "OFF" position because the tank will not refill.
(B) BREW SWITCH
Momentarily pressing and releasing the switch starts a brew cycle
when the "ENABLE BREW ON/OFF" indicator is on.
(C) ADDITIONAL WARMER SWITCHES
(C) ADDITIONAL WARMER SWITCHES
Pressing any additional warmer switch so that the indicator is on,
supplies power to the associated warmer.
NOTE: APS & TC models
have no warmers.
(D) MAIN ON/OFF SWITCH
(D) MAIN ON/OFF SWITCH
This switch, located on the left side of the brewer, turns power on and off
to all components in the brewer.
P3633
39130 020608
COFFEE BREWING
1. Begin each brew cycle with a clean empty brew
1. Begin each brew cycle with a clean empty brew
funnel.
2. Insert a BUNN filter into the funnel.
3. Pour (or grind) fresh coffee into the filter and level
3. Pour (or grind) fresh coffee into the filter and level
the bed of grounds by gently shaking.
4. Slide the funnel into the funnel rails until it stops.
5. Place an empty server under the funnel.
6. Verify that the "ENABLE BREW ON/OFF" indicator
5. Place an empty server under the funnel.
6. Verify that the "ENABLE BREW ON/OFF" indicator
is on.
7. Momentarily press and release the "BREW" switch.
The display will read "NOW BREWING", and show
the time remaining in the brew cycle.
the time remaining in the brew cycle.
8. Following the brew, the display reads "DRIPPING"
which shows the time remaining until the coffee no
longer drips from the funnel tip.
longer drips from the funnel tip.
9. After the coffee finishes dripping from the funnel
tip, carefully remove the brew funnel and discard
the grounds and filter.
the grounds and filter.
B
A
C
NOTE: Some models are equipped with a backup
pour in feature, in case the plumbed water supply is
disrupted. In this event, disregard steps 7-8, and pour
in 64 ounces of fresh water.
pour in feature, in case the plumbed water supply is
disrupted. In this event, disregard steps 7-8, and pour
in 64 ounces of fresh water.
P3969.50