Bunn FMDA DBC-3 Mode D'Emploi

21

BLK to BLU
from Main
Wiring Harness

FIG. 7 BALLAST

Location

The front door lamp ballast is located behind

the front access panel on the left side of the compo-
nent bracket.

Test Procedure
1. Disconnect the dispenser from the power source.
2. Disconnect the two black leads on the ballast from

the dispenser main harness.

3. Check for continuity between the two black leads

on the ballast.

If continuity is present as described the ballast is
operating properly.
If continuity is not present as described, replace the
ballast.

Removal and Replacement
1. Disconnect the wires from the ballast.
2. Remove the two #8-32 screws securing the bal-

last to the component bracket.

3. Remove and discard ballast.
4. Install new ballast using two #8-32 screws to se-

cure ballast to the component bracket..

5. Refer to Fig. 8  when reconnecting the wires.

BLK to Main Wiring

Harness

P1682.40

FIG. 8 BALLAST TERMINALS

P1447

29215 101598