Bunn FMDA DBC-3 Mode D'Emploi

31

FIG. 22 LAMP HOLDERS

P1454.70

Location:

The lamp holders are located on the front of

the upper panel behind the display panel.

Test Procedure:
1. Disconnect the dispenser from the power source.
2. Remove upper door panel (4) and disconnect the

door wiring harness from the leads on the lamp
holders.

3. Remove lamp from lamp holders.
4. Check for continuity on each lead of the lamp

holders.

If continuity is present as described, lamp holders are
operating properly.
If continuity is not present as described replace the
lamp holder.

1

3

4

6

1.

Door Assy

2.

Lamp Holders

3.

Lamp

4.

Upper Panel

5.

Lower Panel

6.

Starter W/Socket

5

2

If continuity is present as described, the hot/cold
switch is operating properly.
If continuity is not present as described, replace the
switch.

Removal and Replacement:
1. Remove all wires from the switch terminals.
2. Remove the mounting nut on the front of the whip-

per motor mounting panel.

3. Remove the hot/cold switch from the rear of the

front panel and discard.

4. Reconnect the wires to the terminals on the rear

of the new switch.

5. Push new hot/cold switch through the hole on the

left side of the whipper motor mounting panel and
secure with mounting nut.

6. Refer to Fig. 21 when reconnecting the wires.

FIG. 21 HOT/COLD SWITCH TERMINALS

P1208

TAN to Main Harness

RED to Main Harness

WHI/YEL to Cold So-

lenoid

29215 101599