Fujifilm 40i Guide D’Installation Rapide
6
7
Windows
Installing the Software
This section describes the setup procedure for using the USB Driver on Windows.
1. Switch on your PC and start up Windows.
(If you are using Windows 2000 Professional, log
on as an Administrator group.)
on as an Administrator group.)
2. Double-click “My Computer”.
✽
When installation is completed, a new removable disk is added.
3. Insert the enclosed CD-ROM into the CD-ROM drive.
4. Load a media containing photographed images
into your camera, switch the camera on and set the
Mode dial to “Playback” mode.
Mode dial to “Playback” mode.
5. Use the USB cable to connect the camera to the
USB port on the PC.
• Connect the cable to the USB port on
the PC. If the cable is connected via a
USB hub, the software may not
operate correctly. If the PC has 2 or
more USB ports, any USB port can be
used.
USB hub, the software may not
operate correctly. If the PC has 2 or
more USB ports, any USB port can be
used.
• Push the USB connector in fully to
ensure that the connection is secure.
If the cable is not securely connected,
the software will not operate correctly.
Refer to the Owner’s Manual supplied
with the camera for details.
If the cable is not securely connected,
the software will not operate correctly.
Refer to the Owner’s Manual supplied
with the camera for details.
• To avoid communication errors, use
the USB cable provided in this
package and do not use an extension
cable.
package and do not use an extension
cable.
✽
✽
Installing the USB Driver
NOTE
Pre-installation Checklist
Installation on a Windows PC
Hardware and software requirements
To run this software, you must have the hardware and software described below. Check
your system before you begin the installation.
your system before you begin the installation.
Compatible PCs
: IBM PC/AT or compatible
(models with USB support as standard)
Operating System
: Windows 98 (including the second edition)
Windows Millennium Edition (Windows Me)
Windows 2000 Professional
(Log on as an Administrator group.)
Windows 2000 Professional
(Log on as an Administrator group.)
CPU
: 200 MHz Pentium or better
RAM
: 64 MB minimum
Hard disk space
: Amount required for installation: 60 MB minimum
Amount required for operation: 110 MB minimum
Monitor
: Screen resolution: 800
× 600 dots or better
Number of display colors: 65,536 or better
• Connect the PC and digital camera directly using the USB cable. Connecting
via USB hub is not guaranteed.
• USB interface board is not guaranteed.
• Windows 95 cannot be used.
• Self-made PC is not guaranteed.
• Do not use USB drivers other than the USB Driver provided on the camera
software CD-ROM. You must update your software to the USB Driver provided
on the CD-ROM.
on the CD-ROM.
If a noise suppression core is enclosed,
fit the core to the communications cable
to reduce emissions of unwanted
electrical noise. If the cable is already
fitted with a noise suppression core, use
the cable as is.
fit the core to the communications cable
to reduce emissions of unwanted
electrical noise. If the cable is already
fitted with a noise suppression core, use
the cable as is.
Noise
suppression core
suppression core
Press until it clicks shut.
Attach the noise suppression core
NOTE