Spectra Logic spectra t120 Mode D'Emploi
Chapter 8. QIP Replacement
47
5.
Go to the rear of the library and locate the QIP using the QIP identifier. Note
that QIPs are numbered from the bottom up (see Figure 8-3).
that QIPs are numbered from the bottom up (see Figure 8-3).
Replacing the QIP
Figure 8-3 QIPs viewed from the back of the library.
1.
Remove all cabling connected to the
QIP itself; cables from the SCSI
ports to the drives may remain in
place.
QIP itself; cables from the SCSI
ports to the drives may remain in
place.
2.
Remove any SFPs and set them aside
for plugging into the new QIP.
for plugging into the new QIP.
3.
Use a #2 Phillips screwdriver to
loosen the two captive screws on the
left side of the QIP (Figure 8-4).
loosen the two captive screws on the
left side of the QIP (Figure 8-4).
Figure 8-4 QIP screws.
QIP 2
QIP 1