LG DLEX3875V Manuel Du Propriétaire

It is important that you review this entire manual before installing and using your dryer. Detailed instructions 

concerning electrical connections, gas connections, and exhaust requirements are provided on the  

following pages.

Do not operate your dryer at temperatures below 45 ºF (7 ºC). At lower temperatures, the dryer might not shut off at the 

end of an automatic cycle. This can result in longer drying times.  

 

 

 

 

 

 

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. 

 

 

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile 

homes or sleeping quarters. Contact your local building inspector. 

 

 

 

 

 

 

NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer.

   A location that allows for proper exhaust installation. 

A gas dryer must be exhausted to the outdoors. See 

Venting Requirements. 

   A grounded electrical outlet located within 2 ft. 

(61 cm) of either side of the dryer. See 

Requirements.

   A sturdy floor to support the total dryer weight of  

200 lbs (90.7 kg). The combined weight of a companion 

appliance should also be considered.

   A level floor with a maximum slope of 1 inch (2.5 cm) 

under entire dryer. If slope is greater than 1 inch (2.5 

cm), install Extended Dryer Feet Kit. Clothes may not 

tumble properly, and automatic sensor cycles may not 

operate correctly if dryer is not level.

   For a garage installation, you will need to place the dryer 

at least 18 inches (46 cm) above the floor. If using a 

pedestal, you will need 18 inches (46 cm) to the bottom 

of the dryer.

   The following spacing dimensions are recommended 

for this dryer. This dryer has been tested for spacing 

of 0 inches (0 cm) clearance on the sides and rear. 

Recommended spacing should be considered for the 

following reasons:

  Additional spacing should be considered for ease of 

installation and servicing.

  Additional clearances might be required for wall, door 

and floor moldings.

  Additional spacing should be considered on all sides of 

the dryer to reduce noise transfer.

  For closet installation, with a door, minimum ventilation 

openings in the top and bottom of the door are required.  

Louvered doors with equivalent ventilation openings are 

acceptable.

  Companion appliance spacing should also be 

considered.

Suggestion: There should be at least a little space around the dryer (or any other appliance) to eliminate the transfer 

of vibration from one to the other. Too much vibration, it could cause them to make noise or touch each other causing 

paint damage and making even more noise.

10