LG DLEX3875V Manuel Du Propriétaire

 

The FLOW SENSE™ duct blockage sensing 
system detects and alerts you to blockages 

in the ductwork that reduce exhaust flow 

from the dryer. This improves operating 

efficiency and helps minimize service calls, 

saving you money. 

If no bars are shown in the 

display, the ductwork is free from 

blockages. 

If two bars in the display are 

lighted, examine the dryer 

exhaust system for lint build up 

or other restrictions, including 

damage, excess length, foreign 

objects, etc. See note below.

If all bars are lit, the dryer 

ductwork has a blockage 

that needs to be removed 

immediately. 

•  Ductwork is slightly too long or has too

many turns/restrictions.

•  Partial blockage of the ductwork due to lint 

buildup.

• Install a shorter or straighter duct run. See

the  Installation Instructions.

• Ductwork should be checked/cleaned soon.  

Dryer can be used in this condition, but 

drying  times may be longer.

• If END OF CYCLE is displayed after the end

of cycle, it will be off in 4 minutes. If POWER 

button is pressed or the door is opened, 

power will be off immediately.

NOTE: If the duct has been checked and 

cleaned and two bars are still displayed after 

several cycles, then there is some restriction 

in the duct due to length, condition, etc.  In 

this case, no further action is necessary and 

the dryer can be used normally.  However, 

drying times may be increased and there may 

be some reduction in operating efficiency

•  Ductwork is too long or has too many turns/

restrictions.

•  Significant blockage of the ductwork due to

lint buildup or debris.

• Install a shorter or straighter duct run. See

the  Installation Instructions.

• Ductwork should be checked/cleaned soon. 

 Dryer can be used in this condition, but 

drying times may be longer.

• If NEED FLOW CHECK is displayed after

the end of cycle, it will be off in 2 hours. If 

POWER button is pressed or the door is 

opened, power will be off immediately.

32