Samsung 230W Giga System Manuel D’Utilisation
6
English
English
6
English
7
Rear Panel
1. 2.0 CH Speaker Connector Terminals
The speaker connector terminals are located on
the rear of the system.
the rear of the system.
1. To achieve the correct sound quality, insert the
speaker connector cables identified below into
the correct speaker terminals on the back of
the system.
• Left speaker (marked L).
• Right speaker (marked R).
the correct speaker terminals on the back of
the system.
• Left speaker (marked L).
• Right speaker (marked R).
2. ONLY FOR SERVICE
• This jack is for service only. Please do not use.
3. AUX IN Terminals
1. Use an Audio Cable (not supplied) to connect
AUX IN on the product to Audio Out on an
external analog component.
• Be sure to match connector colors.
• If the external analog component has only one
external analog component.
• Be sure to match connector colors.
• If the external analog component has only one
Audio Out jack, connect to either the left or
right terminal.
right terminal.
• Press the TUNER/AUX button on the main
unit or press the AUX button on the remote
control to select the AUX input.
control to select the AUX input.
• When the unit is in AUX mode, if none of the
buttons are pushed for more than 8 hours, the
power will automatically turn off.
power will automatically turn off.
4. FM Antenna Connector Terminal
1. Connect the FM antenna (supplied) to the FM
Antenna jack.
2. Slowly move the antenna wire until you find a
location where reception is good, then fasten
it to a wall or other rigid surface.
it to a wall or other rigid surface.
3. If reception is poor, you may need to install an
outdoor antenna. To do so, connect an
outdoor FM antenna to FM antenna jack on
the rear of the system using a 75Ω coaxial
cable (not supplied).
outdoor FM antenna to FM antenna jack on
the rear of the system using a 75Ω coaxial
cable (not supplied).
1
2
3
4
2
3
4