Autodesk autocad electrical 2005 Guide D’Installation Rapide
52
|
Chapter 5 Wire Numbers
7
In the Source/Destination Signal Arrows dialog box, click No.
NOTE
Click No to insert the signal arrows on the next drawing. Click OK to
insert the signal arrows on the current drawing.
8
Click the Next Project Drawing tool to access demo04.dwg.
Now you are ready to insert a destination signal arrow.
Attaching Destination Signal Arrows
Once the source signal arrow is attached to the drawing, you can then attach
a destination signal to a wire segment of a wire network. This enables the
wire number assigned to another source wire network to automatically carry
over to the current network.
a destination signal to a wire segment of a wire network. This enables the
wire number assigned to another source wire network to automatically carry
over to the current network.
To attach a destination signal
1
Click the drop-down arrow on the Source Destination Signals tool to access
the Destination Signal Arrow tool.
the Destination Signal Arrow tool.
Menu
Wires
➤ Signal References ➤ Destination Signal Arrow
2
Respond to the prompt as follows:
Select wire end for Destination: Select the top of the hot wire on the schematic
on the left side of the drawing at line reference 402 (2)
on the left side of the drawing at line reference 402 (2)
2