Sony SRP-X700P Manuel D’Utilisation
1080I (50 and 60 Hz)
VGA Computer Graphics (Modes 1, 2 and 3, 60 - 85 Hz)
VESA 800x600 Computer Graphics (56 - 85 Hz)
VESA 1024 x 768 Computer Graphics (43 – 85 Hz)
VESA 1152 x 864 Computer Graphics (70 – 75 Hz)
SUN 1152 x 900 Computer Graphics (65 – 76 Hz)
VESA 1280 x 1024 Computer Graphics (43 – 60 Hz)
Mac 13” Computer Graphics
Mac 16” Computer Graphics
VGA Computer Graphics (Modes 1, 2 and 3, 60 - 85 Hz)
VESA 800x600 Computer Graphics (56 - 85 Hz)
VESA 1024 x 768 Computer Graphics (43 – 85 Hz)
VESA 1152 x 864 Computer Graphics (70 – 75 Hz)
SUN 1152 x 900 Computer Graphics (65 – 76 Hz)
VESA 1280 x 1024 Computer Graphics (43 – 60 Hz)
Mac 13” Computer Graphics
Mac 16” Computer Graphics
4.0
User Interface / Controllability Information
Control of this device shall be accomplished through one of the following
methods:
Front panel control
Serial control jack for control by external control systems
Advanced serial control jack for control by external control systems
Parallel (Contact closure) control jack for control by external control systems
USB control jacks for control by computer
All of these control methods shall be standard to the device.
In addition, this device shall be able to control other source and display devices.
This shall be accomplished through one or more of the following methods.
Serial control jacks for control of source devices
Serial control jack for control of projector or display
Advanced serial control jack for control of projector or display
All of these control methods shall also be standard to the device.
The front panel control panel shall allow the operator manual control over setup
and configuration of the device. All functions available for control shall be directly
accessible on individual controls, and metering of various audio signals shall be
possible from independent LED’s.
The serial control jack shall employ the use of a standardized device control
protocol that is commonly accepted and understood by control systems
manufacturers. This control jack shall accept unidirectional serial commands that
provide full control over the device.
The following device functions shall be available for control using this method.
Pass through for any compatible projector or display device from projector or
display device remote from supplying manufacturer
methods:
Front panel control
Serial control jack for control by external control systems
Advanced serial control jack for control by external control systems
Parallel (Contact closure) control jack for control by external control systems
USB control jacks for control by computer
All of these control methods shall be standard to the device.
In addition, this device shall be able to control other source and display devices.
This shall be accomplished through one or more of the following methods.
Serial control jacks for control of source devices
Serial control jack for control of projector or display
Advanced serial control jack for control of projector or display
All of these control methods shall also be standard to the device.
The front panel control panel shall allow the operator manual control over setup
and configuration of the device. All functions available for control shall be directly
accessible on individual controls, and metering of various audio signals shall be
possible from independent LED’s.
The serial control jack shall employ the use of a standardized device control
protocol that is commonly accepted and understood by control systems
manufacturers. This control jack shall accept unidirectional serial commands that
provide full control over the device.
The following device functions shall be available for control using this method.
Pass through for any compatible projector or display device from projector or
display device remote from supplying manufacturer