Sony storstation lib-d81 Manuel D’Utilisation

31

Chapter 3  Basic Usage

[d ] and [XX], where “XX” is the error code, appear alternately on the message 
display.

For illustration purposes, we have used the autoloader in error code examples 
throughout the document.

Disaster recovery is a function through which all the data on the host computer 
is backed up on cartridges, which can then be used to restore your system in the 
unlikely event of a catastrophic failure, for example. Perform disaster recovery 
with the application software on the host computer.

For details about operations and settings on the host computer, refer to the 
documentation accompanying the computer and software applications.

Prepare to perform disaster recovery.

Create a disaster recovery tape with the host computer.

Place the AIT drive in Disaster recovery mode.
Send the AIT drive mode selection command from the host computer. 
The AIT drive enters Disaster recovery mode.
You can also place the AIT drive in Disaster recovery mode by following 
the instructions of step 2 below.

Begin disaster recovery.

Insert the disaster recovery tape into slot 1.

Simultaneously press the CLEAN and DOOR buttons at the front of the 
AIT autoloader for at least 5 seconds. The AIT drive enters Disaster 
recovery mode. When the AIT drive enters Disaster recovery mode, [d r] 
appears flashing on the message display.

Turn off the AIT autoloader, wait approximately 10 seconds, then restart 
it.
The disaster recovery tape is automatically inserted into the AIT drive. 
Refer to the documentation accompanying the computer and software 
applications to perform the disaster recovery procedure.