Estate tgp305tt Manuel De Montage

10

Cooktop and oven burners use electronic ignitors in place of
standing pilots. When a cooktop control knob is turned to the
“LITE” position, the system creates a spark to light the burner.
This sparking continues until the control knob is turned to the
desired setting.

When the oven control is turned to the desired setting, a hot sur-
face ignitor heats to a bright orange and ignites the gas. No
sparking occurs. The glow bar remains on while the burner oper-
ates.

1. If control panel and knobs were

removed earlier, reinstall knobs.

2. Push in and turn each surface

unit control knob to “LITE” posi-
tion. The flame should light with-
in 4 seconds. 

3. Turn control knob to “HI” posi-

tion after burner lights. 

4. Check each cooktop burner for

proper flame. The small inner
cone should have a very distinct blue
flame 

¹⁄₄" (6.4 mm) to ¹⁄₂" (13 mm) long.

The outer cone is not as distinct as the
inner cone. 

5. Turn the control knob quickly to the “LO”

position after the burner lights. If the
flame goes out, turn the control knob to the “OFF” position.

6. Check each cooktop burner for proper low flame. The low

flame should be a minimum, steady blue flame. The flame size
should be 

¹⁄₄" to ³⁄₈" (6.4 mm to 9.5 mm) high.

1. Turn control knob to the “LO” setting and remove control

knob.  

2. Insert a small flat-blade screwdriver into the valve stem. Turn

the valve adjusting screw to obtain the smallest flame that will
not go out when the control of a cold burner is quickly turned
from “HI” to “LO”. Turn right to decrease flame height. Turn
left to increase flame height. Repeat for other cooktop burners
as needed.

3. Replace control knob.

1. Locate gas pressure regulator in the broiler.

Do not remove the gas pressure regulator. 

2. Check that the gas pressure regulator shutoff valve is in the

“ON” position.

3. Open the manual shutoff valve in the gas supply line. The

valve is “open” when the handle is parallel to the gas pipe.

4. Test all connections by brushing on an approved noncorrosive

leak-detection solution. Bubbles will show a leak. Correct any
leak found.

5. Close the broiler door.

6. Place burners, burner caps and grates on the cooktop.

7. Plug into a grounded 3-prong outlet.

OFF

LO

LITE

MED

HI

outer

cone

inner
cone

A

B