Telect T3 Manuel D’Utilisation

Issue A Rev 2

108469

Telect, Inc.

To temporarily connect an NE or DCS circuit to an alternate DCS or NE 
circuit on the same or a different DNI-3 panel or DSX without disrupting 
service, follow the steps below, using the Twist Lok Jacks (TLJs) on the 
front of the appropriate DNI-3 panels and the following additional equip-
ment:

•

Four Mini-WECO patch cords (Mini-WECO plug at each end)

•

Two 75-ohm Mini-WECO terminating plugs

•

One dual bridging office repeater (BOR), or two single BORs

1.

Using one Mini-WECO patch cord:

a. Insert the plug of one end into BOR position 1, INPUT.

b. Insert the plug of the other end to the monitor TLJ at the first lo-

cation.

2.

Using a second Mini-WECO patch cord:

a. Insert the plug of one end into BOR position 1, OUTPUT.

b. Insert the plug of the other end into the IN TLJ at the second lo-

cation.

3.

Using a third Mini-WECO patch cord:

a. Insert the plug of one end into BOR position 2, INPUT.

b. Insert the plug of the other end into the monitor TLJ at the sec-

ond location.