Edelbrock 5276 Manuel D’Utilisation

Page 

1 of 2

©2007 Edelbrock Corporation
Brochure No. 63-0454 

Catalog #5276

Rev. 9/07 - DA/mc

Please study these instructions carefully before installing your new Trailing Arms. If you have any questions, please
contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time
or e-mail us at Edelbrock@Edelbrock.com.

Application: Designed for 2005-2008 Ford Mustang vehicles. These trailing arms are designed to stabilize the rear
suspension, while improving suspension articulation.

❑ Jack and proper load rated jackstands

❑ Blue Locktite

❑ Tire chocks

❑ Torque wrench

❑ Lug wrench

❑ Grease gun

❑ 18mm socket and combination wrench 

1.

Place vehicle on level surface and place tire chocks
in front of and behind front tires.

2.

Support rear of the vehicle on the jackstands and
remove the rear wheels 

(See Figure 1).

3.

Place a floorjack under the differential and lift up
slightly to remove tension from the trailing arm
bolts. Make sure not to lift the vehicle off the
jackstands 

4.

With parking brake released, remove clip from
parking brake cable at brake caliper. Slip cable
out of brake caliper and off of parking brake
arm. Thread cable back through trailing arm
(See Figure 2).

5.

Remove trailing arm bolts and trailing arms
(See Figure 3).

6.

Clean attachment points with a wire brush.