RAD Data comm ASM-60 Manuel D’Utilisation

Quick Start Guide 

ASM-60 Installation and Operation Manual 

2 Configuring 

ASM-60 

 

The table below shows the correct status of the indicators a few seconds after 
power-up. 

PWR ON 

TD 

Depends on DTE data transmission 

RD 

Depends on DTE data transmission 

RTS 

Depends on DTE RTS signal status 

DCD 

Depends on remote modem data transmission 

TEST OFF 

ALM OFF 

SYNC A/SYNC B  Green or red, depending on remote modem data 

transmission 

Configure ASM-60 to the desired operation mode via an ASCII terminal using the 
embedded management software. Configuration of the ASM-60 modem includes 
selection of a data rate. 

 

To select the data rate: 
1.  From the Configuration menu, type 1. 

The Data Rate menu appears. 

2.  Select the data rate by typing the number corresponding to the desired value 

and then type 2 to save the changes. 

 

↓ 1 

↓ 1