GE 165D4700P390 Manuel D’Utilisation

Operating Instructions

Safety Instructions

Consumer S

uppor

oubleshooting Tips

Problem

Possible Causes

What To Do

Dishes and flatware

Low inlet water temperature

• Make sure inlet water temperature is correct (see page 8). Turn on the hot

not clean

water faucet nearest the dishwasher; let run until the water temperature
stops rising. Then start the dishwasher and turn off the faucet. This ensures
the entering water is hot.

• Try not to use the dishwasher when hot water is being used elsewhere

in the house; for example, when doing laundry or when a family member
is using the shower.

Water pressure is temporarily low • Turn on a faucet. Is water coming out more slowly than usual? If so, wait

until pressure is normal before using your dishwasher.

• Try not to use the dishwasher when hot water is being used elsewhere

in the house; for example, when doing laundry or when a family member
is using the shower.

Air gap or disposer is clogged

• Clean the air gap or flush the disposer.

Improper rack loading

• Make sure large dishware does not block the detergent dispenser or the

wash arms. See the Loading the dishwasher racks section.

No air gap or high drain loop

• Verify that you have an air gap or a high drain loop. Refer to the

Installation Instructions.

Spots and filming

• Use Cascade Crystal Clear

rinse agents to remove spots and

on glasses and

prevent new film buildup.

flatware

• Make sure water temperature is at least 120°F.
• Load dishwasher as shown in the Loading Place Settings section.
• Make sure detergent is fresh.
• If water is extremely hard, a softener may be required.

Error Messages

Possible Causes

What To Do

START/RESET status

You have pressed the

• Press the START/RESET pad only one time to start the dishwasher. When the

indicator light flashing START/RESET pad while the

dishwasher is running, only press the START/RESET pad if you wish to cancel

dishwasher is running. This will

(reset) the cycle.

cancel the cycle. The light will
stop flashing after the dishwasher
drains (about 90 seconds).

Power to the dishwasher was

• The light will stop flashing after the dishwasher drains out the water. A new

turned off while a cycle was

cycle will start automatically when the drain ends.

running and power has just been
restored to the dishwasher. The
blinking lights indicate that the
dishwasher is draining water
inside.

Dishwasher BEEPS

This is a reminder that your

• Close and latch the door after opening it mid-cycle. Beeping will stop and

once every 15 seconds dishwasher door has been left

dishwasher will complete cycle.

open during operation. It will
continue beeping until you close
the door.

Beeping at the end

This is normal. The dishwasher

• To turn off the double beep indicator (or re-activate it if it was previously

of the cycle

will beep twice at the end of

turned off), press the HEATED DRY pad 5 times within 3 seconds. A triple

the cycle.

beep will sound to indicate the end-of-cycle beep option has been turned
on or off.

Before you call for service…

Troubleshooting Tips
Save time and money! Review the charts on the following
pages, or visit ge.com. You may not need to call for service.

Extremely hard water
Low inlet water temperature
Overloading the dishwasher
Improper loading
Old or damp powder detergent
Rinse agent dispenser empty
Too little detergent