Whirlpool 1188018 Manuel D’Utilisation

2. If the feet on the bottom of the air conditioner do not rest on 

the wood strip, remove the air conditioner and adjust the 
SMART-MOUNT

®

 tray until feet rest on the wood strip.

3. If top channel does not rest against the top of the wall 

opening, remove air conditioner and adjust SMART-MOUNT

®

 

tray until top channel rests against wall.

IMPORTANT: The tray must slope downward slightly toward 
the outside to provide proper drainage for the air conditioner.

4. If the bottom of the air conditioner does not sit against the 

bottom of the SMART-MOUNT

®

 tray, remove air conditioner 

and adjust angle of tray until air conditioner sits against the 
bottom of the tray.

IMPORTANT: The tray must slope downward slightly toward 
the outside to provide proper drainage for the air conditioner.

5. Install screws through the top channel to secure the air 

conditioner into the wall opening.

1. Trim and seal around the air conditioner on the inside and the 

outside. 

NOTE: Allow for removal of the air conditioner at a later time 
for routine annual maintenance.

2. Plug into a grounded 3 prong outlet.

3. Press RESET on the power supply cord plug.

Operating your air conditioner properly helps you to obtain the 
best possible results. 

This section explains proper air conditioner operation.

■

If you turn off the air conditioner, wait at least 3 minutes 
before turning it back on. This prevents the air conditioner 
from blowing a fuse or tripping a circuit breaker.

■

Do not try to operate your air conditioner in the cooling mode 
when outside temperature is below 65°F (18°C). The inside 
evaporator coil will freeze up, and the air conditioner will not 
operate properly.

NOTE: In the event of a power failure, your air conditioner will 
operate at the previous settings when the power is restored.

³⁄₄

A

B

C

A

B

C

A

B