Revolabs 01EXECMICWR Manuel D’Utilisation

 

The local Web UI allows managing an Executive Elite base DSP unit through a 
web browser.  The local web UI can be accessed either through the IP network 
if  the Executive Elite base DSP unit is connected to the LAN using an Ethernet 
cable, or through the USB connector in the front of the base DSP unit. 
Running the local web UI requires Java to be installed on the computer that is 
opening the browser page. 
NOTE:  

Supported web browsers are Microsoft Internet Explorer, Google 
Chrome, and Mozilla Firefox. 

When connecting a Computer for the first time using the USB interface, the PC 
may need to install driver software to enable web access through the USB port.  
This installation could take several minutes.  During this time an installation 
message like this might be shown on the Computer: 

 
 
 
 
 
 
 
 
 
 

If you do not see this or a similar message, the driver may not have 
been successfully installed.  If this occurs, connection to the web 
interface of the Executive Elite System cannot be established 
through the USB port.  This is likely due to your computer’s driver 
update configuration.  If the problem continues, please check if 
your computer has ‘auto update’ disabled and/or contact your 
administrator. 

Once the driver is installed, the front panel LCD will show an overlay with the 
IP address for the USB interface.  The IP address of the USB interface can also 
be found by visiting Main Menu – System Information – Network Information – 
Network Information (USB). 
If the Executive Elite Base DSP unit is connected to the LAN, you can also use 
a computer on the same subnet with no firewall in between to access the web 
UI interface.  The Elite system is factory pre-configured for DHCP and will 
request an IP address from your DHCP server.  The IP address of the LAN 
interface can be determined through the front panel interface by visiting Main