Radiolink Electronic Limited RL037T001A Manuel D’Utilisation

5.Press the SELECT key once to display the flashing % sign. Use the DATA “+” key to set

the percentage of mixing from -100% to +100% (depending on the direction and distance

you wish the slave servo to move).

6.Press SELECT key four times to call the screen for selecting the on/off switch. Then

select the switch by pushing DATA “+” or “-” key. CH5, D/R, or FLP switch (include the on

direction) is selectable. The “ON” is “always on”.

7.Observe how the controls on the model respond to be certain you have achieved the

correct mix and that the throws are as desired.

Wing Mixing Type Selection (ACRO only)

With the programmable mix (previously described) the user determines the two channels to be mixed. The wing mixing

function is another mix that may be used, but the channels mixed are predetermined. There are three different wing

mixing functions to select from:

*If necessary, use the Servo Reversing

function to achieve the correct direction

of servo throws.

FLPR Flaperon mixing (ACRO only)

This function allows the ailerons to be used both as ailerons and as flaps. The flap

control switch (CH 6) operates the flap function. To use flaperon mixing both

ailerons must be operated by separate servos.

To activate flaperon mixing:

1. Connect the aileron servo in the right wing to channel 1 (aileron) in the receiver and

connect the aileron servo in the left wing to channel 6 (flaps) in the receiver.

2. Enter the programming mode. Access the

“FLPR” screen with the MODE“▲”or“▼” key.

You cannot set “Flaperon” mixing when “Elevon” mixing has already been set. In order to

enable “Flaperon” mixing, you first need to cancel “Elevon” mixing. However, it is allowed to

use “Flaperon” and “V-Tail” mixing simultaneously.

3. Press the DATA “+” key. This will cause the flashing “INH” display to change to a flashing

“ON” display. Now the mixing is on.