CipherLab Co. Ltd. 11661 Manuel D’Utilisation
3
2. Installation
The 1166P/1266P kit contains:
A 1166P/1266P wireless barcode scanner
A 3666 base
A rechargeable battery
A Serial/Keyboard/USB Cable (depending on configuration ordered)
A power supply for the base or the scanner.
Diskette containing “Scan Manager” and this manual
Note: Please refer to chapter 5 Bluetooth Serial Port for
Bluetooth Serial Port installation and configuration
instructions.
instructions.
2.1 Power Up the 3666 Base Station
Connect the interface cable into the 15-pin connector at the back of the base. The
interface of the cable depends on you ordered. There are three types of cables
available: RS232, Keyboard or USB.
interface of the cable depends on you ordered. There are three types of cables
available: RS232, Keyboard or USB.
Power off your PC or Laptop when connect the cable to PC or Laptop. Once your
cable is connected to the base, plug the other end into the appropriate port on your
PC. For example, if you have a serial cable then plug into the com port of your PC,
if you have a Keyboard cable then plug into keyboard port of your PC and if you
have a USB cable plug into the USB port on your PC.
cable is connected to the base, plug the other end into the appropriate port on your
PC. For example, if you have a serial cable then plug into the com port of your PC,
if you have a Keyboard cable then plug into keyboard port of your PC and if you
have a USB cable plug into the USB port on your PC.
Connect the power supply provided to your AC outlet and plug the other end into
the base then power on your PC.
the base then power on your PC.
Now you are ready to configure your scanner and base.
4
2.2 Power Up the 1166P/1266P
When you receive your 1166P/1266P, the battery is separated from 1166P/1266P.
Please insert the battery into the bottom of the scanner and lock the battery by
pushing the clip to power on the scanner. The scanner will beep and the LED will
be on when power on.
Please insert the battery into the bottom of the scanner and lock the battery by
pushing the clip to power on the scanner. The scanner will beep and the LED will
be on when power on.
Please ensure to remove the battery to power off the scanner if it will not be used
for a prolonged period. The LED will be off and the power to the scanner will be
disconnected.
for a prolonged period. The LED will be off and the power to the scanner will be
disconnected.
2.3 Setup RF Connection
Upon powering up the scanner will try to establish an RF connection with its base.
At this stage we need to “pair” the scanner and base.
At this stage we need to “pair” the scanner and base.
Turn the base upside down and you will find 2 labels.
The first label has the words “SET CONNECTION” and a barcode. The second
label is the serial number.
label is the serial number.
To link the scanner to the base, scan the “SET CONNECTION” barcode label, the
scanner will beep once then scan the SERIAL number barcode. The scanner will
beep twice, low then high beep. When it establishes RF connection with the base
the scanner will then emit three short ascending beeps. Your “pairing” is
established.
scanner will beep once then scan the SERIAL number barcode. The scanner will
beep twice, low then high beep. When it establishes RF connection with the base
the scanner will then emit three short ascending beeps. Your “pairing” is
established.
Push up to lock the battery.