Spectronic Denmark A/S 90136040 Manuel D’Utilisation

Quick Start Guide

INCA Repeater 

The most important thing we build is trust

80011422 

Sept. 2014 - Version 1.4.1

INCA Repeater Software Configuration

To configure the INCA Repeater software:
1.  Connect the INCA Repeater to a computer containing the INCA Repeater Setup Utility software. 
2.  The power LED will illuminate Orange to indicate the INCA Repeater is receiving power via the USB.

Note: 

Connecting external power to the INCA Repeater is not required when programming the INCA Repeater.  The INCA Repeater is 

powered via USB for software configuration.
3.  Select the Operating Mode in the Operation Tab - (Repeater, Receiver (RX) only, or Transmitter (TX) only).
 

Note: 

The specified operating mode will determine what options and settings are available when configuring the INCA Repeater.

4.  Set the Activate Condition in the Operation Tab.

Note: 

The RSSI activate condition is only available when operating the device in Repeater mode.

5.  Set the Audio Path options in the Operation Tab.

Note: 

Two audio paths exist with-in the INCA Repeater.  One for on-site listening (repeater location) and the other for the rebroadcasted 

signal.  The operating mode determines which configuration options for the audio path are available.
6.  Set the required Frequencies, Volume, and Power level in the Main Tab.

Note: 

If the user is employing the device in Repeater mode the recommended technique is to invert the RX frequencies with the TX 

frequencies ensuring the paired TX and RX frequency contains at least 100 MHz of frequency separation between paired channels. 

INCA Repeater Remote Commands

0

On

4

N/A

8

Channel 3

C

Power Level 3

1

Off (sleep mode)

5

N/A

9

Channel 4

D

Power Level 4

2

N/A

6

Channel 1 

A

Power Level 1

E

N/A

3

N/A

7

Channel 2

B

Power Level 2

F

N/A