Xirgo Technologies Inc. XT3630F Manuel D’Utilisation
8
These configurations mean that the device will report the data packet per the established protocol to the
SIGFOX backend every 10 minutes. The GPS data is configured to be a minimum 50m accuracy to allow locking
at challenging locations. If the device is successfully awake. You will get data packets in the portal as shown
below:
SIGFOX backend every 10 minutes. The GPS data is configured to be a minimum 50m accuracy to allow locking
at challenging locations. If the device is successfully awake. You will get data packets in the portal as shown
below:
The devices will begin to report once every 10 minutes.
3.3 USB Serial Cable Connection
To interface with the device for serial communication you must set up the RS-232 to USB adapter cable.
Connect USB cable from the cable harness to a PC. Install the drivers for the corresponding operating system on
the computer. The driver can be downloaded from the URL below:
Connect USB cable from the cable harness to a PC. Install the drivers for the corresponding operating system on
the computer. The driver can be downloaded from the URL below:
When the drivers are successfully installed, you should be able to see a USB COM port for the XT3630. Pick the
correct COM port for the XT3630 by looking for USB COM port under the ‘Ports’ section within Windows Device
Manager. Use the following terminal application settings:
correct COM port for the XT3630 by looking for USB COM port under the ‘Ports’ section within Windows Device
Manager. Use the following terminal application settings:
1) Bits per second: 115200
2) Data bits: 8
3) Parity: None
4) Stop bits: 1
5) Flow control: None
2) Data bits: 8
3) Parity: None
4) Stop bits: 1
5) Flow control: None
See the next section for setting up a recommend terminal program, ZOC Terminal.