Agri-Fab 45-0331 Manuel D’Utilisation

5

(1)   

Knife or Scissors

(2)   

1/2" Open End or Box End Wrenches

All loose parts are shown on page 2. Fasteners in the parts 
bag are shown full size on page 3. 

Remove the hardware pack and all loose parts from the 
carton and verify that all the parts and fasteners shown on 
pages 2 and 3 are included.

SAFETY ........................................................................... 4
ASSEMBLY ...................................................................... 5
OPERATION .................................................................. 11
MAINTENANCE ............................................................ 11
STORAGE ..................................................................... 11
SERVICE AND ADJUSTMENTS ................................... 12
TROUBLESHOOTING ................................................... 12
REPAIR PARTS ............................................................. 22

Note:  Right hand (R.H.) and left hand (L.H.) are determined 
from the operator's position while seated on the tractor.

1.  (Figure 1)  Assemble the angle bracket to the sweeper 

housing using a 5/16" x 3/4" hex bolt (F) and a 5/16" 
hex lock nut (G). Make sure the bracket is turned as 
shown and aligned straight with the housing and then 
tighten.

2.  Cut off the plastic tie that holds the height adjustment 

tube in place.

3.  (Figure 2) Assemble the R.H. hitch tube to the sweeper 

housing using two 5/16" x 1-1/2" carriage bolts (D), 
5/16" lock washers (K) and 5/16" hex nuts (H). Do not 
tighten yet. Repeat for the L.H. hitch tube.

4.  (Figure 3) Fasten the hitch tubes together using two 

5/16" x 2-1/2" hex bolts (A), 5/16" small fl at washers 
(I), 5/16" lock washers (K) and 5/16" hex lock nuts (G). 
Do not tighten yet.