Brodit ProClip 854928 854928 Fascicule

1.

2.

4.

3.

Please read all of the instructions and look at the pictures before attaching the ProClip.  
 
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape
cover on the ProClip. Press the angled edge on the upper part of the ProClip into the seam between the
dashboard ledge and the thin panel below the navigation screen panel. Then flip the ProClip downward so the
lower angled edge on the ProClip hooks behind the panel.  
 
2. Push upward on the bottom part of the ProClip so it flexes upward. Let the ProClip rest on top of the air vent
panel.  
 
3. Press the thin end of the enclosed L shaped gap opener into the gap between the center console and the air
vent panel next to the ProClip, to widen the gap. Then press firmly forward on the lower part of the ProClip so the
angled edge goes into the gap next to the gap opener. Note: If the gap is tight pull the panel slightly towards you
using the gap opener while pushing forward on the ProClip. Push until you see or hear/feel it click into place. Pull
out the gap opener.  
 
4. The ProClip is in place.