Fenix LD22 FENIX LD22 Fiche De Données

Ⴟ  Push-button tail cap switch with momentary-on function 

Ⴟ  Side mode switch in the front, fast and convenient   

Ⴟ  Made of durable aircraft-grade aluminum 

Ⴟ  Premium Type III hard-anodized anti-abrasive finish 

Ⴟ  Toughened ultra-clear glass lens with anti-reflective coating 

Notice: The above-mentioned parameters (lab-tested with 2500mAh Lithium battery) are 

approximate and may vary between flashlights, batteries and environments. 

Turning on/off 

Press the tail cap switch lightly to momentarily activate the flashlight.    Press the tail cap switch 

completely to turn on the flashlight and lock it. Another press will turn it off. 

Mode selection 

A single press on the side mode switch allows switching between Turbo

ൺLowൺMidൺHighൺ

brightness levels; 

Press and hold the side mode switch for about one second to enter into Strobe mode. 

Press and hold the side mode switch for about three seconds to enter into SOS mode. 

While in Strobe or SOS mode, a single press on the side mode switch returns you to the 

non-flashing mode. 

LD22 memorizes the brightness level while in the general mode. When turned off and then on, the 

flashlight automatically enters the general (non-flashing) mode. 



Ni-MH battery 

AA 

1.2V 

Recommended

෭෭෭෭

Alkaline battery 

AA 

1.5V 

Usable 

෭෭෭෭

Non-rechargeable Battery 

(Lithium) 

AA 1.5V Usable 

෭෭෭෭

Rechargeable Battery 

(Li-ion) 

14500 3.7V  Banned 

™™™™

Warning: please do not mix o using batteries of other manufacture, capacity, size or type. Doing so 

will cause damages to the batteries or flashlights.

Notice: When use 2 fresh alkaline batteries, maybe due to the high voltage, the brightness of the 

Low level will be close to that of the Mid in the early stage. However, after working some time, 

the brightness of the Low will perform normally. 

Unscrew the tail cap to put in the battery with the anode side (+) toward the light head.    Simply 

screw the tail cap back on to test.