Lappkabel UNITRONIC® Bus cable EIB 2 x 2 x 0.8 mm² Green 2170240 Fiche De Données
Codes de produits
2170240
DATA SHEET
2170240
UNITRONIC
®
BUS EIB
gültig ab :
13.10.2009
elaborated by:
Petra Samek, PDC
Petra Samek, PDC
Dokument:
DB2170240DE05
Blatt 1 von 1
Nr.: 0019/0408
Application
Screened installation cable based on type J-Y(ST)Y in acc. to VDE 0815 for data transmission in the building
management, in particular as bus cable for the European Installation Bus “EIB” (use for decentralised control of
lighting, heating, air-conditioning, ventilation, energy management, blind, time management, locking systems
etc.). The EIB bus cable can be laid in, on and under plaster, in pipes and cable ducts, in dry, damp and wet
rooms. They may only be installed outdoors with UV-protection and in observation of the temperature range.
UNITRONIC
management, in particular as bus cable for the European Installation Bus “EIB” (use for decentralised control of
lighting, heating, air-conditioning, ventilation, energy management, blind, time management, locking systems
etc.). The EIB bus cable can be laid in, on and under plaster, in pipes and cable ducts, in dry, damp and wet
rooms. They may only be installed outdoors with UV-protection and in observation of the temperature range.
UNITRONIC
®
BUS EIB cables have been tested with a test voltage of 4 kV. The cables may be laid respectively
be touched without restrictions next to power cables.
Design
Conductor
Solid, bare copper wire, Ø 0.8 mm diameter
Insulation
special PVC-based compound
Core identification pair 1: red and black, pair 2: white and yellow
Stranding
Stranding
4 insulated conductors twisted (star-quad formation)
Wrapping
plastic foil
Screening
one layer plastics-coated aluminium foil, wrap metal side inside with Ø 0.4 mm
bare copper drain wire
bare copper drain wire
Sheath
special PVC-based compound, Ø max. 6.6 mm
Sheath colour
green, similar to RAL 6017
Electrical properties at 20°C
Conductor resistance
max. Ω/km
73.2
Insulation resistance
min. MΩ x km
100
Mutual capacitance at 800 Hz
nom. nF/km
100
Inductance at 800 Hz
mH/km
0.65
Capacitive coupling k at 800 Hz
max. pF/100 m
300
Characteristic impedance at 100 kHz
nom. Ω
85
Characteristic impedance at 1MHz
nom. Ω
75
Attenuation at 10 kHz
nom. dB/km
3.5
Attenuation at 100 kHz
nom. dB/km
8
Operating voltage (not for power purposes)
peak value V
300
Test voltage (conductor/conductor)
V
1000
Test voltage (conductor/screen)
V
1000
Test voltage of the cable in water bath (5 min.)
V
4000
Mechanical and thermal properties
Minimum bending radius (fixed use)
cableØ
x 10
Permissible pulling strength
max. N
100
Permissible temperature range (fixed use)
°C
-30 to +70
Flame propagation
flame retardant acc. to IEC 60332-1-2
Conformity
This cable confirms to RoHS directive (2002/95/EG)