Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Fiche De Données

Codes de produits

1-F8075

125

<Model Menu (Airplane/Glider Functions)>

● Select the function name

and return to the Model

menu by touching the

R T N b u t t o n . 　 O r t h e

H O M E / E X I T b u t t o n i s

pushed.

<SensorTouch™>

RETURN

RUDDER 2

RUDDER

V-TAIL

RUDDER 2

Winglet

RUDDER 1

Winglet

at Flying wing

( )

AIL 3

(Chip Aileron)

AIL1

(Main Aileron)

AIL 2

(Main Aileron)

RUD to AIL

[Corresponding model type]: Airplane/glider, general

This function is used when you want to mix

the ailerons with rudder input. It is used when

rudder is applied during roll maneuvers such

as, knife edge flight. It can be used to turn or

bank scale models, large models, etc. like a full-

size aircraft.

● Mixing during flight can be turned ON/OFF by

setting a switch. (Always ON at [--] setting)

● Linking can be set: Link this mix to other mixes.

● The mixing rate can also be adjusted.

● A 5-point curve can be set at airplane model type.

● Select [RUD to AIL] at the Model

menu and access the setup screen

shown below by touching the RTN

button.

*The display screen is an example.

The actual screen depends on the

model type.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

Setting method
●Activate the function

Move the cursor to the [ACT] item and touch

the RTN button to switch to the data input

mode. Select the ACT mode by scrolling the

touch sensor.

*The display blinks.

Touch the RTN button to activate the

function and return to the cursor mode. (ON

is displayed.)

When setting a switch, move the cursor to

the [SW] item and touch the RTN button to

call the selection screen. Select the switch

and set its ON direction. (Always ON at "--"

setting)

*For a description of the switch selection method, see the

description at the back of this manual.

●Mixing rate adjustment (glider)

Move the cursor to the left or right item

and touch the RTN button to switch to the

data input mode. Adjust the mixing rate

independently by scrolling the touch sensor.

Initial value: 0%
Adjustment range: -100~+100%

*When the RTN button is touched for one second, the rate is

reset to the initial value.)

Touch the RTN button to end the adjustment

and return to the cursor mode.

●Link mode setting

To activate the link mixing, move the cursor

to the [LINK] item and touch the RTN button

to switch to the data input mode. Select the

ON mode by scrolling the touch sensor.

*The display blinks.

Touch the RTN button to set the link mode

and return to the cursor mode.

(Glider: Currently selected condition name)