Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Fiche De Données

● Select the function name 

and return to the Model 

menu by touching the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s 

pushed.

ELEVATOR

(RUDDER 2)

RUDDER

(ELEVATOR 2)

[Corresponding model type]: Airplane/glider, V-tail

This function enables adjustments for left and 

right rudder angle changes during elevator and 

rudder operation of a V-tail airplane.

V-tail is when two servos are used together to 

control rudder movement as elevators. In addition 

to each elevator side moving up and down together, 

each side moves in opposite directions when moving 

as rudders. On a V-tail, this is also known as a 

Ruddervator, as they serve the same purpose.

(Rudder function)
  L e f t   a n d   r i g h t   t r a v e l 

a d j u s t m e n t   o f   r u d d e r 

operation

(Elevator function)
  Up and down travel adjustment of 

elevator operation

● Select [V-TAIL] at the Model menu and 

access the setup screen shown below 

by touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

  Move the cursor to the item you want to 

adjust and touch the RTN button to switch to 

the data input mode.

  Adjust the rate by scrolling the touch sensor. 
  Initial value: +50%
  Adjustment range: -120~+120%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

  Touch the RTN button to return to the cursor 

mode.

*If the mixing direction is reversed, adjustments can be made 

by changing the mixing rate polarity (+ or -).

*If a large value of travel is specified, when the sticks are 

moved at the same time, the controls may bind or run out of 

travel. Decrease the travel until no binding occurs.