Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Fiche De Données

● Select the function name 

and return to the Model 

menu by touching the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s 

pushed.

[Corresponding model type]: Airplane, general

This function selects the switch and rate 

adjustment of ailerons, elevators, and rudder when 

a snap roll is performed.

● Four snap roll directions can be set. (Right/up, 

right/down, left/up, left/down)

● Operation mode: When [Master] mode is selected, 

the Snap Roll function is turned ON/OFF by the 

master switch.  It is possible to set the direction 

switch was switched to the direction in which you 

want to snap roll. When [Single] mode is selected, 

the snap roll in each direction can be executed 

by means of independent switches and positions.

●  A  safety  switch  can  be  set  to  prevent  the 

inadvertent  activation  of  the  snap  roll.  For 

example, the landing gear is lowered, even if 

the switch is turned on accidentally the snap roll 

would not be executed. The snap roll switch is 

activated only when the safety switch is OFF.

● Mode: [Master]
● Safety SW: [SG] (Safety measure)
● Master SW: [SH] (Main switch for executing 

snap roll)

● Direction switches:

*The snap roll up side left and right and down side left and right 

direction switches are selected here.

Right/Up: OFF [SD]

Right/Down: OFF [SD]

Left/Up: OFF [SA]

Left/Down: OFF [SA]

●  Master/single  mode 

selection

● Select [SNAP ROLL] at the Model menu 

and access the setup screen shown 

below by touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

● Direction switches