Intel E3815 FH8065301567411 Fiche De Données
Codes de produits
FH8065301567411
Intel
®
Atom™ Processor E3800 Product Family
1804
Datasheet
30:24
0h
RW
Back-End Power Control (pwr_ctrl):
Each bit of this field controls back-end power
supply for an embedded device. Host interface voltage (VDDH) is not controlled by this
field. The number of devices supported is specified by Number of Clock Pins, and a
maximum of 7 devices can be controlled.
•
•
D24 Back-end Power Control for Device 1
•
D25 Back-end Power Control for Device 2
•
D26 Back-end Power Control for Device 3
•
D27 Back-end Power Control for Device 4
•
D28 Back-end Power Control for Device 5
•
D29 Back-end Power Control for Device 6
•
D30 Back-end Power Control for Device 7
The function of each bit is defined as follows:
•
•
0 = Back-end Power is Off
•
1 = Back-end Power is Supplied
Back-End power control is effective for embedded memory devices in the Sleep State
that support the Sleep command (CMD14) to reduce power consumption and embedded
SDIO devices when IOEx is set to 0.
23
0b
RO
RSVD1:
Reserved
22:20
0h
RW
Interrupt Pin Select (int_pin):
Interrupt pin inputs are enabled by this field. Enable
of unsupported interrupt pin is meaningless.
•
•
000b = Interrupt is detected by theInterrupt Cycle.
•
xx1b = INT_A is enabled
•
x1xb = INT_B is enabled
•
1xxb = INT_C is enabled
19
0b
RO
RSVD2:
Reserved
18:16
0h
RW
Clock Pin Select (clk_pin):
One of clock pin outputs is selected by this field. Selection
of unsupported clock pins is meaningless. Refer to Figure 2-38 for the timing of clock
outputs.
•
•
000b = Clock Pins are disabled
•
001b = CLK[1] is selected
•
010b = CLK[2] is selected
•
. . .
•
111b = CLK[7] is Selected
15
0b
RO
RSVD3:
Reserved
14:8
0h
RO
Bus Width Preset (bus_width):
Shared bus supports mixing of 4-bit and 8-bit bus
width devices. Each bit of this field specifies the bus width for each embedded device.
The number of devices supported is specified by Number of Clock Pins, and a maximum
of 7 devices are supported. This field is effective when multiple devices are connected to
a shared bus (Slot Type is set to 10b in the Capabilities register). In the other case,
Extended Data Transfer Width in the Host Control 1 register is used to select 8-bit bus
width. As use of 1-bit mode is not intended for shared bus, Data Transfer Width in the
Host Control 1 register should be set to 1.
•
•
D24 = Bus width preset for Device 1
•
D25 = Bus width preset for Device 2
•
D26 = Bus width preset for Device 3
•
D27 = Bus width preset for Device 4
•
D28 = Bus width preset for Device 5
•
D29 = Bus width preset for Device 6
•
D30 = Bus width preset for Device 7
The function of each bit is defined as follows:
•
•
0 = 4 bit buswidth mode
•
1 = 8 bit buswidth mode
7:6
0b
RO
RSVD4:
Reserved
Bit
Range
Default &
Access
Field Name (ID): Description