Yaesu FT-857D Mode D’Emploi

You can also store “Split” frequencies, such as when operating on a repeater system not utiliz-
ing a “standard” offset. This procedure may also be used for DX work on 7 MHz SSB, etc.

1. In the VFO mode, set the desired Receive frequency and mode.
2. Press the [FUNC] key momentarily, then rotate the SELECT knob, as needed, until

Multi Function Row “b” [MW, SKIP, TAG] appears on the display.

3. Press the [A](MW) key momentarily to enter the “Memory Check” mode, which is used

to find an unused memory channel. The Memory Channel Number notation at the upper
left corner of the LCD will blink, and the frequency stored (if any) on the selected memory
channel will be shown in the display. Rotate the SELECT knob to select the channel on
which you wish to store the receive frequency data.

4. Press and hold in the [A](MW) key for one second until you hear two beeps (a second

apart), which confirms that the Receive frequency data is now stored.

5. Now, set the desired Transmit frequency and mode on the VFO.
6. Press the [A](MW) key momentarily; do not rotate the SELECT knob!
7. While the Memory Channel Number is blinking, press and hold in the PTT switch; while

holding it in, press and hold in the [A](MW) key for one second.

8. The two beeps will confirm that independent Transmit frequency data is now stored. You

may now release the PTT switch.

 “R

” M