Whirlpool ACS088PR0 Manuel D’Utilisation

Operating your air conditioner properly helps you to obtain the best possible results. 

This section explains proper air conditioner operation.

IMPORTANT: 

■

If you turn off the air conditioner, wait at least 3 minutes 
before turning it back on. This prevents the air conditioner 
from blowing a fuse or tripping a circuit breaker.

■

Do not try to operate your air conditioner in the cooling mode 
when outside temperature is below 66°F (19°C). The inside 
evaporator coil will freeze up, and the air conditioner will not 
operate properly.

■

In the event of a power failure, your air conditioner will 
automatically turn back on.

■

If the electronic control will not respond to touch pad or 
remote control commands, it is necessary to unplug the air 
conditioner from the electrical outlet for 5 seconds before 
plugging back in.

NOTE: If the room temperature is below 55ºF (13ºC), the display 
will show 55ºF (13ºC). If the room temperature is above 99ºF 
(37ºC), the display will show 99ºF (37ºC).

1. Remove clear protective film from control panel and front 

panel badge.

2. Set air exchanger. See “Air Exchanger.”

3. Press POWER to turn on air conditioner.

NOTE: When air conditioner is turned on for the first time 
after it is plugged in, it will display the default settings: Cool 
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is 
turned on at all other times, it will display the previous 
settings for 3 seconds, and then display the room 
temperature.

4. Choose mode. See “Mode.”

5. Choose fan speed. See “Fan Speed.”

6. Choose temperature. See “Temperature.”

Set the Air Exchanger control to CLOSED for maximum 
continuous cooling. The Air Exchanger set to OPEN circulates 
fresh air and draws stale or smoky air from the room.

■

Open—to exhaust room air to the outside

■

Closed—maximum air circulation and cooling

1. Press MODE until you see the indicator light come on for the 

setting you desire.

2. Choose Cool, Fan Only or Power Saver.  

■

Cool—Cools room. Press FAN SPEED to choose fan 
speed. Then adjust the temperature by pressing the plus 
or minus buttons.  

■

Fan Only—Only the fan runs. You can select the fan 
speed by pressing FAN SPEED, but you cannot adjust the 
Temperature control setting. Display shows the current 
room temperature. 

■

Power Saver—Fan runs only when cooling is needed. You 
can select the fan speed by pressing FAN SPEED.
Because the fan does not circulate the room air 
continuously, less energy is used, but the room air is not 
circulated as often. Use Power Saver when you are 
asleep or away from home.

F

G

A

B

C

D

E

H