Bunn G9-2T HD DBC Manuel Du Propriétaire

9

*Hash mark settings.  Refer to Burr Adjustment section.

33736  030205

Three different batch settings are selectable for each hopper. Each batch is independently adjustable by set-

ting the length of time a slide gate opens to allow beans to drop into the grinding chamber. A second time setting 

for each batch determines how long the grind motor continues to run after the slide gate closes. This time is set 

long enough to insure that all the beans dropped into the grind chamber are ground and dispensed.

1.  Determine the grind setting. (The factory setting is drip, to determine other settings, refer to the previous 

section.)

2.  Use the table below to find approximate timer setting for the grind and amount of coffee desired.

3.  To enter the setup mode and make an adjustment, press and hold the hidden programming pad under the 

®. One of the batch indicators will begin to flash off and on.  At this point, release the ® button.

4.  Push the hopper/batch selector button for the batch to be adjusted. Note that the digital display shows the 

current slide gate time setting (in seconds).

5.  To increase the time, press the GRIND button.  To decrease, press the STOP button.

6.  To change the chamber clean-out time, press the same batch button again and note that the indicator light 

begins to blink more rapidly and the display shows the current clean-out time.

7.  To increase the time, press the GRIND button. To decrease it, press the STOP button.

8.  After the cleanout time has been entered, press another batch pad and repeat steps 4 to 7. Otherwise, to exit 

the programming mode, press and release the ® pad and the grinder returns to the normal operating mode, 

using the new settings.

NOTE: While in the setup mode, if no buttons are pushed for 60 seconds, the grinder will return to normal opera-

tions, retaining any settings made while in the setup mode.