Whirlpool WTW4800BQ Manuel Du Propriétaire

Page de 32
3
IMPORTANT:
• After the washer basket fills to the selected water level, the lid must be closed before the wash cycle can start. 
  If filling stops with the lid open, close lid and press START button.
• Rinse option must be selected to 1 Rinse with Softener or 2 Rinses with Softener to ensure fabric softener  
  dispenses at the correct time.
Sounds
 At different stages of the wash cycle, you may  
hear sounds and pauses that are different from 
those of your previous washer. For example, you 
may hear a clicking and hum at the beginning of  
the cycle as the lid lock goes through a self-test. 
There will be different kinds of humming and  
whirring sounds as the agitator tests for load  
balance or moves the load. And, sometimes,  
you may hear nothing at all as the washer allows 
time for clothes to soak.
Spray Rinse
 
Select cycles default to a spray rinse. During these 
cycles, you will hear water enter the washer as the 
tub spins, allowing the rinse water to penetrate 
clothes. Check the “Cycle Guide” for details.
WHAT’S NEW UNDER THE LID?
Your new washer will operate differently than your past agitator-style washer.
Lid Lock
  To allow for higher spin speeds, the lid will lock and 
the Lid Locked light will turn on. When this light is 
lit, the lid is locked and cannot be opened. When 
this light is blinking, the washer is paused. When 
this light is off, the lid can be opened. After a cycle 
is started, water will enter washer and then lock. If 
you need to open the lid to add a garment after this 
point, you must press START/Pause and wait for the 
lid to unlock. The lid will only unlock after washer 
movement has stopped. Depending on when in the 
cycle you try to pause, it may take several seconds 
to several minutes for the lid to unlock. Press START/
Pause to resume the cycle.
Sensing
This washer will perform a series of spins to check  
for load balance. During this time, a series of clicks 
and a whirring noise signal that sensing technology 
is determining if there is an off-balance load.