Westinghouse WP2700 Manuel Du Propriétaire
25
OPERATION
6. WP3000 – Move the throttle lever to the full throttle
position (see Figure 28). Move the choke lever to
the choke position. Open the fuel shutoff valve.
the choke position. Open the fuel shutoff valve.
1
2
3
4
Figure 28 – Throttle Lever, Choke Lever, Fuel Shutoff
Valve
1 - Throttle Lever
2 - Choke Lever
3 - Fuel Shutoff
Valve
4 - Starter Handle
7. Firmly grasp and pull the starter handle slowly until
you feel increased resistance. At this point, apply a
rapid pull on the starter handle.
rapid pull on the starter handle.
OTE:
N
If the engine starts briefl y and then shuts off,
squeeze the trigger on the spray gun to relieve
the pressure before trying to start the engine
again.
squeeze the trigger on the spray gun to relieve
the pressure before trying to start the engine
again.
8. Once the engine starts, move the choke lever to the
open position. Allow the engine to warm up slightly
before beginning washing.
before beginning washing.
OTE:
N
WP3000 – Always operate the engine at full
throttle position when washing.
throttle position when washing.
STOPPING THE PRESSURE
WASHER
WASHER
Normal Operation
During normal operation, use the following steps to stop
your pressure washer:
your pressure washer:
1. Lock the spray gun trigger lock in the OFF position.
2. Move the engine ON/OFF switch to the OFF (O)
position (see Figure 29 and Figure 30).
Figure 29 – Engine ON/OFF Switch OFF Position –
WP2700
Figure 30 – Engine ON/OFF Switch OFF Position –
WP3000