Bunn G9WD RH Manuel Du Propriétaire

Page de 15
4
41451.0001  031111
d
a
b
c
e
OPERATING CONTROLS
Grind Pad (a)
 
Pressing initiates a grind cycle.
Stop Pad (b)
 
Pressing ends the operation of the grinder.
® Pad (c)
 
Pressing the copyright pad allows programming access.
Pads (d)
 
“Hidden” buttons used to navigate setup and programming menus.
Pads (e)
 
Press button to select small, medium or large batch size.
ELECTRICAL REQUIREMENTS
Refer to Data Plate on the Grinder, and local/national electrical codes to determine circuit requirements.
This grinder has an attached cordset and requires 2-wire, grounded service rated:
 
120 volts ac, 15 amp, single phase, 60 Hz, for domestic grinders. 
 
230 volts ac, 10 amp, single phase, 50 Hz, for most international grinders. 
 
100 volts ac, 15 amp, single phase, for some international grinders.
CE REQUIREMENTS
• This appliance must be installed in locations where it can be overseen by trained personnel.
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specified in conformance with all local and national codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have been given instructions concerning use of this appliance by 
a person responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
 If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with a special 
cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.
• Machine must not be immersed for cleaning.
• Machine rated IXP1.