Enterasys Networks SecureStack C2 C2RPS-POE Manuel D’Utilisation
Installing the C2RPS-POE on a Flat Surface
SecureStack C2 Installation Guide 2-3
Installing the Rubber Feet
1.
Place the C2RPS‐POE on its back on a sturdy flat surface to gain access to the bottom
of the chassis.
of the chassis.
2.
Remove the four rubber feet from their plastic bag in the shipping box.
3.
Locate the four marked locations on the bottom four corners of the C2RPS‐POE.
Figure 2-1 C2RPS-POE Bottom, Rubber Feet Placement
4.
Remove the protective strip from the back of one rubber foot and position it on a
marked location and press firmly into place. Repeat this procedure to install the
remaining three rubber feet.
marked location and press firmly into place. Repeat this procedure to install the
remaining three rubber feet.
5.
After installing the rubber feet, return the C2RPS‐POE to its upright position.
6.
To install the C2RPS‐POE on a flat surface, proceed to “
” on page 2‐2. For a rackmount installation, proceed to “
1 Bottom of C2RPS-POE
3 Rubber feet with adhesive backing (4)
2 Locations to install the rubber feet (4 locations)
À
Á
Â
Â
Â
Â