Whirlpool Compact Washe Manuel D’Utilisation

■

Is the power cord plugged into an earthed 3 prong outlet? 
Plug power cord into an earthed 3 prong outlet.

■

Are you using an extension cord? Do not use an extension 
cord.

■

Is the indicator on the Cycle Control knob properly lined 
up with a cycle? Turn the Cycle Control knob to the right 
slightly and pull to start.

■

Are the water inlet valve screens clogged? Turn off the 
water and remove inlet hoses from the washer. Remove any 
accumulated film or particles. Reinstall hoses, turn on water 
and check for leaks.

■

Are both the hot and cold water faucets turned on? Turn 
on the water.

■

Is the water inlet hose kinked? Straighten the hoses. 

■

Does the water level seem too low, or does the washer 
appear to not fill completely? The top of the agitator is 
much higher than the highest water level. This creates a 
perception that the washer is not filling completely. This is 
normal.

■

Has a household fuse blown, or has a circuit breaker 
tripped? Replace the fuse or reset the circuit breaker. If the 
problem continues, call an electrician.

■

Is the washer in a normal pause in the Casual/Permanent 
Press (or Hand Washables) cycle?
The washer pauses for about 2 minutes in the Casual/
Permanent Press cycle. Allow the cycle to continue.

The Hand Washables cycle (on some models) features 
periods of agitation and soak. 

■

Is the washer overloaded? Wash smaller loads.

■

Is the lid open? The lid must be closed during operation. 
Washer will not agitate or spin with the lid open.

■

Is the top of drain hose lower than the water level in 
washer? The top of the hose must be higher than the water 
level in the washer for proper operation. See the Installation 
Instructions.

■

Does the drain hose fit too tightly in the standpipe, or is it 
taped to the standpipe? The drain hose should be loose yet 
fit securely. Do not seal the drain hose with tape. The hose 
needs an air gap. See the Installation Instructions.

■

Is the drain hose clogged, or the end of the drain hose 
more than 183 cm above the floor?
See the Installation Instructions for proper installation of drain 
hose.

■

Is the lid open?
The lid must be closed during operation. Washer will not 
agitate or spin with the lid open.

■

Is there excessive sudsing?
Always measure detergent. Follow manufacturer’s directions. 
If you have very soft water, you might need to use less 
detergent. 

■

Is your voltage low?
Check your electrical source or call an electrician. Do not use 
an extension cord. 

■

Is the load balanced, and is the washer level? 
The wash load should be balanced and not overloaded.

The washer must be level. The front feet should be properly 
installed and the nuts tightened. Reset the rear leveling legs 
(if needed). See the Installation Instructions.

■

Did you completely remove the yellow shipping strap with 
cotter pins?
See the Installation Instructions.

■

Are the gears engaging after the drain and before spin, or 
is the upper part of agitator clicking during wash?
These are normal washer noises.