Radio Shack 43-3908 Manuel D’Utilisation

If desired, use the lapel clip on the headset cord to attach 
the cord to your clothing. Leave enough slack in the cord so 
you can move your head without pulling the headset.

Insert the tabs on the headset holder into 
the slots on the back of the base and snap 
the holder into place.

Use the belt clip to hang the handset on your belt or 
waistband for handsfree carrying.

You can select either a high or low ringer tone setting on the 

handset while the phone is not in use. Lift the handset and 

press 

 to hear the current ringer setting. 

Repeat-edly press 

to select the desired 

ringer setting.

Your phone is set for tone dialing. If you have pulse service, 

change the dialing mode. If you are not sure which type of 

service you have, do this test.

1. Lift the handset and listen for a dial tone.

2. Press any number other than 

.Ô

If the dial tone stops, you have touch-tone service. If the dial 

tone continues, you have pulse service.

To set the dialing mode, hold down 

 until the phone 

beeps and TALK/BATT flashes, then press 

 to set the phone 

to pulse mode or 

∗

 to set the phone to tone mode.

To make a call, lift the handset and press 

. To answer a 

call, simply lift the handset. Or, if the handset is not in place 
on the base, press 

 or any number key, 

, or 

∗

. 

The TALK/BATT indicator on the handset and the 
CHARGE/IN USE indicator on the base light.

To end a call, place the handset on the base or press 

. 

The TALK/BATT and CHARGE/IN USE indicators turn off. Ô

Ô

Ô

• If your phone system requires 

that you dial an access code (9, 
for example) before you dial an 
outside number, do not dial the 
access code.

• The phone exits setting mode if 

a call or page is received, or if 
you press END.

• If the battery power becomes 

too low, the dialing mode might 
reset to tone. If you are on a 
pulse line and cannot make a 
call, try setting the dialing mode 
to pulse.

If the handset is too far from the 
base while the phone is in use, 
pressing END might not disconnect 
the phone. Hang up the handset on 
the base.

If the handset is too far from the 
base, an error tone sounds and the 
channel might not change. Move 
closer to the base.

• The redial memory holds up to 

24 digits, so you can redial long-
distance as well as local 
numbers.

• The redial memory also holds 

pause entries (see “Entering a 
Pause” on Page 9).

• The redial memory stores a 

flash entry or any digits you 
press after FLASH (see “Using 
Flash” on Page 8).

If you do not have any special 
phone services, pressing FLASH 
might disconnect the current call.

43-3908.fm  Page 7  Thursday, December 19, 2002  3:12 PM