Jensen VM9022 Manuel D’Utilisation

22

VM9022

Press the SRC button (8) on the front panel or remote control 
(8) to switch to the SAT source. 

1.

SAT channel name

2.

SAT channel number

3.

SAT band

4.

Time

5.

Song title

6.

Artist name

7.

Song category

8.

Signal strength indicator

9.

Current preset channels/on-screen preset buttons

10. CH -: Select the previous channel
11.

CH +: Select the next channel

12. CAT +: Select next channel in current category only

13. CAT -: Select previous channel in current category only
14. Touch to enter channel directly using keypad on screen
15. CG: Access Channel/Category Guide mode
16. BAND: Change between SAT1, SAT2 and SAT3 bands
17. Touch to view the SETUP menu
18. Touch this area to view the SOURCE MENU and select 

a new playback source

19. MEM: View screen used to enter current channel into 

preset memory

20. DIAG: This feature is reserved for use by service 

professionals for troubleshooting.

Before you listen to satellite radio, you must subscribe to the 
service using your radio’s identification number. To display 
the radio ID, press the left/right buttons (16, 17) on the 
joystick or the CH - or CH + buttons on the touch screen 
repeatedly to tune to channel “000”. The screen displays the 
radio ID where the channel name is usually displayed.

Use the left/right joystick buttons or the CH - or CH + buttons 
on the touch screen to change to another station.

To enter preset mode, touch the BAND button on the screen, 
or press the BAND button on the unit (14) or remote control 
(20) to change between the following bands: SAT1, SAT2, or 
SAT3 (indicated in the top left corner of the TFT screen).

Six numbered preset buttons store and recall stations for 
each band. All six stored stations (P1-P6) for the current 
band appear on the TFT screen.

Storing a Station
1.

Select a band (if needed), then select a station.

2.

Touch the on-screen MEM button (18) to open the 
preset screen.

3.

Touch the preset number in which you would like to 
store the current station (or press EXIT to cancel and 
close the menu). The preset number and station 
appears highlighted.

Recalling a Station
1.

Select a band (if needed).

2.

Touch an on-screen preset button to select the 
corresponding stored station.

To enter a radio station directly, touch the 

 button or 

press the GOTO button (21) on the remote control to display 
the direct entry menu.

Enter the desired radio station using the on-screen number 
pad. Touch the Enter button to tune to the selected station. 
To exit the screen without changing the station, touch Exit. To 
clear your entry and start over, touch Clear.

There are two search modes to help navigate through 
channels and or categories. To access the Channel/Category 
Guide mode, press the Enter (joystick) button (18) on the 
remote control or the CG button on the touch screen.

Channel Guide is the default search mode. To access 
Category Guide, press the TITLE button (2) on the remote 
control or touch CAT on the touch screen. To return to 
Channel Guide, touch CH on the screen or press the 
SUBTITLE button (9) on the remote control.

When Channel Guide mode is selected, the first six satellite 
channels are displayed in the boxes in the bottom left of the 
TFT screen and the on-screen menu changes to facilitate 
search mode.

+

-

+

-

Mem:

E x i t

P1 P2

P3

P4 P5 P6

CH NO: _ _ _ /255

1

2

3

4

5

6

7

8

9

0

Clear

Exit