Cooper Bussmann 858 Manuel D’Utilisation
9
Installation
NOTICE
Sign foundations/pad and their design are the responsibi
installer and/or airport and recommendations/suggestions herein are
for guidance only.
covers, series isolation transformers
isolation transformer secondary cable extend
consolidating harness
ground wire and connectors, floor flange anchor bolts and hardware
are not included as part of the sign.
from Crouse
installer and/or airport and recommendations/suggestions herein are
for guidance only.
covers, series isolation transformers
isolation transformer secondary cable extend
consolidating harness
ground wire and connectors, floor flange anchor bolts and hardware
are not included as part of the sign.
from Crouse
a. Refer to FAA AC 150-5345-18F section 14 for Taxiway Guidance Sign location and for the
perpendicular distance from the defined pavement edg
section 25 of FAA AC 150-5345
perpendicular distance from the defined pavement edge to the near side of the sign
section 25 of FAA AC 150-5345
perpendicular distance from the defined pavement edge to the near side of the sign
IMPORTANT
FAA specifications and Engineering Briefs may be obtained by
searching the FAA web
searching the FAA web
b. See Figures 12-17 for suggested concrete foundation/pad. Concrete foundations/pads should be of
adequate mass, reinforcement, and psi strength rating for the
body and floor flange anchors must endure at its maximum plus a safe
foundation/pad should be installed in soil conditions that will help facilitate drainage and
foundation/pad support. The floor
sustained force on the sign body
25684-1 Floor Flange. See Table 14
body and floor flange anchors must endure at its maximum plus a safe
foundation/pad should be installed in soil conditions that will help facilitate drainage and
foundation/pad support. The floor
sustained force on the sign body
25684-1 Floor Flange. See Table 14
c. Concrete foundations/pads should extend at least 12 inches below the local frost line. Contact your
local or regional building inspector if the depth is unknown for your area.
extend at least 1 foot beyond the sign body to minimize damage from mowers.
extend at least 1 foot beyond the sign body to minimize damage from mowers.
Instruction Manual
AGS-LED
858 LED Series
Sizes 1, 2, 3, 4 and 5
3
WARNING
:
Sign foundations/pad and their design are the responsibi
installer and/or airport and recommendations/suggestions herein are
for guidance only. Transformer housing and baseplates
installer and/or airport and recommendations/suggestions herein are
for guidance only. Transformer housing and baseplates
series isolation transformers, primary connector kits
isolation transformer secondary cable extender, series isolation
consolidating harness (if required), heat shrink kits, grounding rods,
ground wire and connectors, floor flange anchor bolts and hardware
are not included as part of the sign. Underlined items may be ordered
from Crouse-Hinds Airport Lighting.
consolidating harness (if required), heat shrink kits, grounding rods,
ground wire and connectors, floor flange anchor bolts and hardware
are not included as part of the sign. Underlined items may be ordered
from Crouse-Hinds Airport Lighting.
18F section 14 for Taxiway Guidance Sign location and for the
perpendicular distance from the defined pavement edge to the near side of the sign.
5345-18F for Runway Distance Remaining Sign location and
perpendicular distance from the defined pavement edge to the near side of the sign.
WARNING:
FAA specifications and Engineering Briefs may be obtained by
searching the FAA web site:
searching the FAA web site:
www.faa.gov
.
for suggested concrete foundation/pad. Concrete foundations/pads should be of
adequate mass, reinforcement, and psi strength rating for the maximum sustained force on
body and floor flange anchors must endure at its maximum plus a safety margin. The concrete
foundation/pad should be installed in soil conditions that will help facilitate drainage and
body and floor flange anchors must endure at its maximum plus a safety margin. The concrete
foundation/pad should be installed in soil conditions that will help facilitate drainage and
dation/pad support. The floor flange anchor bolt material should also meet the maximum
sustained force on the sign body plus a safety margin and must be ½ inch in diameter for use with the
Table 14 for estimated maximum sustained force on the sign body.
Concrete foundations/pads should extend at least 12 inches below the local frost line. Contact your
al or regional building inspector if the depth is unknown for your area. The foundation/pad should
extend at least 1 foot beyond the sign body to minimize damage from mowers.
DOCUMENT 1025
REV. B
Sign foundations/pad and their design are the responsibility of the
installer and/or airport and recommendations/suggestions herein are
installer and/or airport and recommendations/suggestions herein are
and/or
connector kits, series
series isolation
grounding rods,
ground wire and connectors, floor flange anchor bolts and hardware
tems may be ordered
18F section 14 for Taxiway Guidance Sign location and for the
Similarly, see
Remaining Sign location and
FAA specifications and Engineering Briefs may be obtained by
for suggested concrete foundation/pad. Concrete foundations/pads should be of
maximum sustained force on the sign
ty margin. The concrete
foundation/pad should be installed in soil conditions that will help facilitate drainage and
flange anchor bolt material should also meet the maximum
margin and must be ½ inch in diameter for use with the
sustained force on the sign body.
Concrete foundations/pads should extend at least 12 inches below the local frost line. Contact your
The foundation/pad should