FMC Corporation - Talstar 80 Manuel D’Utilisation

Proline Promass 80 PROFIBUS PA

Installation

25

1.

Unscrew cover of the electronics compartment from the transmitter housing.

2.

Press the side latches on the display module and remove the module from the electronics 
compartment cover plate.

3.

Rotate the display to the desired position (max. 4 x 45 ° in both directions), and reset it onto 
the electronics compartment cover plate.

4.

Screw the cover of the electronics compartment firmly back onto the transmitter housing.

a0003236

Fig. 20: 

Turning the local display (field housing)

Perform the following checks after installing the measuring device in the pipe:

4 x 45°

Notes

Is the device damaged (visual inspection)?

-

Does the device correspond to specifications at the measuring point, including 
process temperature and pressure, ambient temperature, measuring range, etc.?

Notes

Does the arrow on the sensor nameplate match the direction of flow through the 
pipe?

-

Are the measuring point number and labeling correct (visual inspection)?

-

Is the orientation chosen for the sensor correct, in other words suitable for sensor 
type, fluid properties (outgassing, with entrained solids) and fluid temperature?

Notes

Is the measuring device protected against moisture and direct sunlight?

-