Autostart CT-1010 Manuel D’Utilisation

 

 

P. 4 

Installation Guide

 

Programmable 500mA negative output: 1/10-sec., 7/10-sec., 4-
sec. or double 1/4-sec. pulse (ON 250 ms, OFF 500 ms, ON 
250 ms) 

This pin provides +12V output for INV-200 module 

Programmable 500mA negative output: 1/10-sec., 7/10-sec. or 
4-sec. pulse  

These wires serve as a starter kill.  Cut the factory starter wire (from the vehicle) in half and connect the two cut 
wires to the 14 AWG purple wires on the module. 

How to Flash the Hood Pin 

• 

Press and hold the hood pin for 4 seconds. 

 

• 

Release the hood pin. 

Parking Lights “ON” 

• 

While the parking lights are on, press down the hood pin once more 
and release the hood pin immediately. 

“ON” for 20 seconds 

• 

You now have 20 seconds to select one of the sub-menus 

 

 

Programming a Transmitter  

The transmitter does not come pre-programmed and must be programmed after the wiring of the module is 
completed. The system can retain up to 4 different transmitter codes; if a fifth transmitter is programmed, the 
code of the first transmitter in memory will be lost. To erase all transmitters from memory, perform a module 
reset. 
Proceed as follows to program a new transmitter: 

1. 

Flash the hood pin (see above) - the parking lights will stay on for up to 20 seconds.  

2. 

Before the lights go out, turn the ignition key to the ON (RUN) position 

3. 

When the lights are off, turn the key to the OFF position. 

4. 

Press and hold the 

 or 

 button until the parking lights flash 5 times quickly. 

5. 

The transmitter has been stored in memory. 

6. 

To exit: close the hood. 

To program a transmitter on the second vehicle for multi-car operation, you must press the 

 button 

(instead of 

 or 

) in step 4 of the transmitter programming procedure.

 
Programming Options   

The system is equipped with two custom programming menus that allow the installer to custom-fit the outputs of 
the system according to the requirements of each vehicle. 

1. 

Flash the hood pin switch (see above) 

 the parking lights will stay on for up to 20 seconds.  

2. 

Before the lights go out, press and hold the valet button and then press one of the following 
buttons: 

............................................to access mode 1; 

............................................to access mode 2;  

3. 

The parking lights will flash to confirm entry into a mode. 

4. 

Release the valet button