Whirlpool Washer Front-Loading Automatic Washer Manuel D’Utilisation

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -  

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.  

Door not closed completely.

Make sure the washer door is closed completely.

Press and hold the START/PAUSE button 2-5 seconds.

Household fuse is blown or circuit 

breaker has tripped.

Check that the household fuse is intact and tight, or that the 

circuit breaker has not tripped. Replace the fuse or reset the 

circuit breaker. If the problem continues, call an electrician.

Washer will not run

START/PAUSE button not pressed 

firmly or held long enough.

Incorrect power supply.

This washer requires a 120-volt power supply.  

Check with a qualified electrician.

Wrong type of fuse.

Use a time-delay fuse.

Fill hoses not attached tightly.

Tighten fill-hose connections. 

Make sure all 4 fill hose washers are installed correctly.

Drain hose connection not correct.

Properly secure drain hose to drainpipe or laundry tub. Refer to 

the Installation Instructions for additional information.

Check household plumbing for leaks 

or clogged sink or drain.

Water can backup out of a clogged sink or drainpipe. Check all 

household plumbing for leaks (laundry tubs, drain pipe, water 

pipes, and faucets.)

Fill hose washers missing.

Water leaks

Do not place tape over drain opening.

Other performance  

or operation issues

Refer to the built-in troubleshooting 

feature on the washer.

See the instructions above to access the built-in TROUBLESHOOT 

menus using the MORE INFO button.

Clean the door seal. See “Washer Maintenance.”

Door seal is dirty.

Use only HE High Efficiency detergents and follow the  

manufacturer’s recommendations.

Not using HE detergent or using too 

much HE detergent.

Remove and clean the dispenser. See “Washer Maintenance.”

Dispenser is clogged.

min

Press and hold START/PAUSE to begin cycle.

Warm/Cold

Extra High

Normal

Off

Est. Cycle Time

With the washer on, press MORE INFO to access the built-in 

troubleshooting feature. Use the LCD control buttons to select ALL 

INFO CATEGORIES. Then use the LCD control buttons to select the 

TROUBLESHOOT topic. 

The t

 and u buttons can be used to advance through the different 

options and categories.

Single-dose laundry 

packet

Packet not dissolving.

Make sure single-dose laundry packet is added to washer drum 

before adding clothes. Follow the manufacturer’s recommendations.