Whirlpool Washer Front-Loading Automatic Washer Manuel D’Utilisation

Page de 36
6
USING THE PRECISION DISPENSE DISPENSER
Powdered detergent:  
Add directly to the 
compartment.
Place a measured amount of detergent 
in the powdered HE detergent 
compartment. 
Use only High Efficiency 
(HE) detergent.
Precision Dispense Ultra cartridge
Adding detergent for a single load
IMPORTANT: 
n
  Do not use liquid detergents in the single-load 
compartment; liquid detergents may seep out of the 
detergent compartment before the main wash begins.
n
  A single dose of liquid detergent can be added to the 
Single-Dose Liquid HE Detergent Cup, which you can 
purchase (see “Accessories” section).
n
  Do not add single-dose laundry packet to dispenser 
drawer.
n
  If you are using the Delay Wash option, use of the 
dispenser cartridge is recommended, or powdered 
detergent may be used in the HE powdered detergent 
compartment.
Powdered HE 
detergent  
compartment
To use the dispenser drawer:
1.  Open the dispenser drawer.
2.  Add laundry products as described in steps 4–6.
Tab
Use only HE High Efficiency  
liquid detergents. The dispenser  
cartridge will hold about 18.5 oz.  
(550 ml) of HE liquid detergent,  
or enough for up to 36 loads
To Fill:
Pull back on the tab and  
lift the fill door. Fill to the  
“MAX” line (see illustration  
at right) with HE liquid  
detergent. Close fill door.  
It will click into place.
To Install the  
Dispenser Cartridge: 
1.  Pull out the dispenser drawer.
2.  Insert the dispenser cartridge completely in detergent 
compartment as shown. It should click into position.
3.  Slowly slide the dispenser drawer in until it is completely 
closed. The washer will automatically detect the 
dispenser cartridge.
4.  Adjust the detergent concentration and water hardness 
settings, if needed. Default settings are 2x detergent 
concentration and normal water hardness. If the 
detergent concentration is not listed on the package, 
see “About Detergent Concentration” to calculate the 
concentration.
 
To Adjust Dispenser Settings:
 1.  Press PRECISION DISPENSE.
 2.   Select the desired settings using the  
 LCD control buttons.
NOTE: The dispenser cartridge should be rinsed out when 
changing detergents or when the washer will not be used 
for extended periods. For instructions on cleaning the 
dispenser cartridge, see “Washer Maintenance”.
 
 
The number of loads will vary, depending on detergent concentration,  
load size, cycle used, and soil level. The maximum capacity of up to  
36 loads requires use of 6x concentration detergent.
Powdered HE detergent
Lift out the cartridge and set aside. 
If you frequently alternate between two different 
liquid HE detergents, you may purchase an additional 
Precision Dispense Ultra cartridge, part number 
W10250743A.
See “Accessories” for ordering information.
Liquid HE detergent
3.  Slowly close the dispenser drawer. Make sure it is  
completely closed. 
NOTE: A small amount of water may remain in the dispensers 
from the previous wash cycle. This is normal.
Use only High 
Efficiency (HE) 
detergent.
“MAX” line